santa...red and green pipe cleaners

 I scanned the santa face to my computer

then I opened it into  my Print Master program

 I bought at Target..

I set up an Avery project for a--return label -- added the santa face   
above
when I added it to the Avery label 'space'
I didn't fill the whole label I
 made it a smaller size 
then the return label ..

then when it printed out it was a full 11 x 8.5 sheet

 (as that Avery return label sheet is) it was a full sheet ..

multiple faces.. 

this is what I did 

wasn't the easiest..but 

all I can say is do what you can to make the faces approx. 1 inch high by 1/2 inch wide..after they are trimmed they are smaller (:)

 I found the chenille pipe cleaners  at 
Hobby lobby..

the red  and green fat bumpy ones

 plus some regular red pipe cleaners for the arms...

below is what you'll need

printed out santa faces ..they will be rectangular so

cut them duh (:)

out around the head and beard..

 wire cutters

 needle nose pliers

 scissors

 tacky glue

 

 cute out the faces

above

 

two santas

 one p cleaner is the hat..body..legs..feet

 can be made from the one cleaner

put the thin part over your finger ..bend it 

 cut off the foot

 bend the feet up a little

 add the arms behind the neck area..

 twist it around you may have to scoot it down

 a little after it on

 snip the tree

 twist the red hand around the tree base tightly

 with needle nose pliers curl up the empty hand some

 glue the face on